husqvarna motorcycle transmission repair in news
husqvarna motorcycle transmission repair news
husqvarna motorcycle transmission repair news.Make sure the ignition timing is correct 2.Adjust the valves as necessary to ensure proper operation 3.
Run the engine to warm it up a bit 4.
Adjust the float setting.
Reinstall installation and idle adjustment 1.
First you must adjust the idle.
This usually involves screwing them then backing out 1 to 1.
Or you can adjust looking at the sliders 2.
If installing the carburetors: a.
Insert the slide assembly into the chamber and make sure it easily slides up and down.
Screw assembly together and verify via throttle movement that slide moves freely.
With the ignition off, kick 1 or 2 times 4.
Do the same for the second carburetor with the first spark plug cap shorted.
Sharply increase, then decrease throttle.
Then engine must return to low rpms smoothly.
Using the flow meter of your choice make sure each carburetor is the same at the various throttle settings.
Place the motorcycle on the center stand ensuring the rear wheel is suspended 2.
Shift into the highest gear with the engine running 4.
Reconnect other cylinder and using the opposite carburetor determine the speed which should be the same as the first.
Adjust the position of this slide to achieve the referenced speed using the locknut at the top of the carburetor.
Ï»¿ reinstall facility and baseless accommodation 1.
Or you can set looking at the slithered 2.
Set the office of this coast to achieve the referenced speed using the locknut at the top of the carburetor.
Ï»¿ or you can set looking at the slithered 2.
Set the office of this coast to achieve the referenced speed using the locknut at the top of the carburetor.
Ï»¿ set the office of this coast to achieve the referenced speed using the locknut at the top of the carburetor.. husqvarna motorcycle transmission repair
Motorcycle bottom end r... (4:08:22)
211,892 views
"www.rockymountainatv.com - How-to disassemble and rebuild the crank and transmission ..."
"www.rockymountainatv.com - How-to disassemble and rebuild the crank and transmission ..."
Комментариев нет:
Отправить комментарий